Not making Cotton Candy Turn heat switch. Shorter extension
cord to no more than 10 feet. Make
sure heat control is turned up all the
way up. See heat control sheet.
Pick a cone; if it sticks in the stack of cones, twist it off the stack.
Hold an inch or two of the pointed end of the cone between two fingers and a thumb. With a light flicking action, roll cone in the web of floss building up in the pan. Lift the cone up with the ring of floss attached and rotate the cone to wrap the floss. DO NOT roll floss while the cone is inside the pan. This will pack the floss too tightly.
If the floss sticks to the cone, pass the cone near the spinner head to pick up a "starter” of melted sugar. Lift the cone out of the pan and wrap the floss with a figure eight movement of the hand. This leaves giant pockets and makes the final product appear larger.
Make sure room humidity is not
too high, or product will be to firm.
FLOATER ADJUSTMENTIn operation, the floss will collect on the FLOSS STABILIZER. If the floss collects "low” on the
stabilizer, twist the front (leading) edge of the leather floaters down. You get more lift and the flosswill collect hotter.
Form leather floaters as shown. This creates a lifting action to float the floss along the outside ofthe floss pan.
When completing operation for the day (or any prolonged period), run all the sugar out of the flosshead. When empty, turn the heat to highest position for approximately one minute to "clean” the
band by baking off remaining sugar. NEVER put water in the floss head.
Heat Control Setting Test
2. With main switch still OFF, fill floss head. Always fill it 90% full with sugar. This 90% level is necessary to obtain a balanced condition in the floss head. DO NOT OVERFILL! Excessive vibration will occur if overfilled. Before turning the power on, manually spin the head to balance out the sugar. This will eliminate excessive vibration of the head.
Important: NEVER add sugar when motor is running.
3. Turn MAIN SWITCH and HEAT SWITCH "ON."
4. Turn heat control knob clockwise to maximum setting to intiate the fastest possible warm up.5. The machine should start making floss in a few seconds. When the unit reaches proper heat, it
may start to smoke. Turn the heat control knob counter clockwise to eliminate smoking.
6. Once you find the ideal setting for the HEAT CONTROL, operate the setting near this position each time.