Make CC - Cotton Candy How To 

Your Price: $0.00
Not for Sale.
Part Number:Cotton Candy 

How To Make Cotton Candy

Make Cotton candy:
  1. Put the cotton candy bowl over the head of the cotton candy machine
  2. Fill the cotton candy head with flossugar about 90%, do NOT fill all the way!
  3. Turn the motor & heat dials on
  4. Turn heat control knob clockwise to maximum setting to initiate the fastest possible warm up.
  5. The machine should start making floss in a few seconds. When the unit reaches proper heat, it may start to smoke. Turn the heat control knob counter clockwise to eliminate smoking. Let the machine do all the work
  6. Pick a cone; if it sticks in the stack of cones, twist it off the stack.
  7. Hold an inch or two of the pointed end of the cone between two fingers and a thumb.
  8. With a light flicking action, roll cone in the web of floss building up in the pan.
  9. Lift the cone up with the ring of floss attached and rotate the cone to wrap the floss. DO NOT roll floss while the cone is inside the pan. This will pack the floss too tightly.
  10. If the floss sticks to the cone, pass the cone near the spinner head to pick up a "starter” of melted sugar. Lift the cone out of the pan and wrap the floss with a figure eight movement of the hand. This leaves giant pockets and makes the final product appear larger.

Clean the machine after the end of each event or day:

  • When completing operation for the day (or any prolonged period), run all the sugar out of the flosshead. When empty, turn the heat to highest position for approximately one minute to "clean” the band by baking off remaining sugar. NEVER put water in the floss head.
  • With a cloth dampened with warm/hot water. Only wipe the head and body of the machine. Make sure the cloth is not dripping wet, because you do not want water to run into electrical components
  • Wrap the cord around the head of the machine when done

Store in dry, clean place

How to Printable sheet

Trouble shoot sheet

Related Items

Recently Viewed Items